JupiteX Get the app
Environment & Climate16 Nov 2026 · about 7 min

When fog meets smog: Decoding Delhi-NCR’s low-visibility mornings

The brief

The surprising part is that the same morning’s low visibility was described in three different ways. Fog, smog and haze are not always easy to separate, and meteorologists have no universally accepted rules for drawing the line. In India, humidity, visibility and air quality help experts describe conditions. On November 16, experts called the early hours fog because humidity was high and pollution levels were comparatively lower. After about 9:30am, humidity fell below 75% while visibility stayed below 1,000 metres; experts described that period as smog. Visibility rose above 1,000 metres after about 11:30am, and the air was then described as haze, with pollutants remaining. This sequence shows why a single label may not describe conditions for an entire morning. The article notes that IMD officials record low visibility as fog, then clarify whether it was fog or smog when asked, using moisture and air quality. There is no fixed record-keeping definition, so local conditions and the time of observation matter.

01

How did experts describe Delhi-NCR’s air on November 16 as the morning progressed?

The surprising part is that the same morning’s low visibility was described in three different ways. Fog, smog and haze are not always easy to separate, and meteorologists have no universally accepted rules for drawing the line. In India, humidity, visibility and air quality help experts describe conditions.

On November 16, experts called the early hours fog because humidity was high and pollution levels were comparatively lower. After about 9:30am, humidity fell below 75% while visibility stayed below 1,000 metres; experts described that period as smog. Visibility rose above 1,000 metres after about 11:30am, and the air was then described as haze, with pollutants remaining.

This sequence shows why a single label may not describe conditions for an entire morning. The article notes that IMD officials record low visibility as fog, then clarify whether it was fog or smog when asked, using moisture and air quality. There is no fixed record-keeping definition, so local conditions and the time of observation matter.

02

How low did visibility fall, and when did it rise above the 1,000-metre threshold?

The article does not give a precise lowest visibility reading for November 16. It says visibility fell from 6,000 metres to levels classified first as mist and then fog. That distinction matters: the article’s 50-metre reading belongs to November 9, the day after Diwali, not to November 16.

For practical descriptions in India, meteorologists treat visibility below 1,000 metres, or 1 kilometre, as low. On November 16, visibility remained below that threshold after about 9:30am, while humidity had fallen below 75%; experts called this period smog. After about 11:30am, visibility increased to more than 1,000 metres.

That improvement changed the description to haze, according to Mahesh Palawat, who said pollutants remained in the air as moisture dropped. The article’s figures therefore show a threshold crossing, not a complete clearing of pollution. It also highlights why the time of a reading matters: visibility and humidity changed as the morning progressed.

03

What do meteorologists mean by fog, smog, and haze?

Fog has a clear core feature in the article: it is water droplets suspended in air close to the ground. That is why humidity matters. The article describes smog less as a separate, universally defined category and more as a label experts use when low visibility coincides with moisture below 75% and polluted air.

In India, meteorologists commonly count visibility below 1,000 metres as low. On November 16, experts called the early hours fog when humidity was high and pollution comparatively lower. After about 9:30am, humidity dropped below 75% while visibility remained low, so they described conditions as smog. Once visibility exceeded 1,000 metres after 11:30am, they used haze.

These terms are not perfectly exclusive. The article says there are no universally accepted rules for distinguishing fog and smog, and IMD officials record low visibility as fog before clarifying conditions using moisture and air quality. It gives no formal threshold-based definition of haze; in this account, the term describes the later period with better visibility but pollutants still present.

04

Why can fog and smog be present at the same time?

Fog and smog can be present together because fog describes moisture in the air, while smog describes polluted air; the two conditions are not mutually exclusive. The article stresses that fog does not discount pollutants or smog, which makes a clear distinction difficult on some mornings.

On November 16, particulate matter data showed that visibility fell from 6,000 metres toward mist and then fog while both humidity and PM2.5 and PM10 concentrations were increasing. Experts called the early period fog because humidity was high and pollution comparatively lower, but the presence of particles meant air pollution had not disappeared. The article says moisture and particulate matter can mix, making haze denser.

This overlap is especially likely because weather conditions that favour fog also favour smog. The article reports that humidity was above 75% on almost all early mornings that November, while air quality on most mornings had been in the very poor category. As a result, a morning’s reduced visibility could involve moisture, fog or mist, and pollution together, rather than one simple category.

05

How can low visibility affect people travelling by road or air?

The article focuses on classifying Delhi-NCR’s air, not on reporting crashes, delays or travel restrictions. Still, low visibility matters to travellers because it reduces how far ahead people can see. As general safety knowledge beyond the article, drivers may have less time to spot other vehicles or hazards, while pilots and air-traffic teams may need to adjust operations when visibility is poor.

The article gives a sense of how severe conditions can become: visibility fell to 50 metres on November 9, and on November 16 it remained below 1,000 metres after about 9:30am. It also notes that the IMD’s aviation meteorology procedures include thresholds for classifying mist. That mention does not say what flights did on either day.

For travellers, the key point is that conditions can change during the morning. On November 16, visibility rose above 1,000 metres after about 11:30am, but the article says pollutants remained. Low visibility can therefore affect what people can see even as its cause and the appropriate label shift. The source provides no specific travel advice or recorded impacts.

06

How do humidity and airborne particles combine to make the air harder to see through?

Water droplets and airborne particles can both contribute to air that is harder to see through. The article explains that fog consists of water droplets near the ground, while pollution adds particulate matter. It says particles mix with moisture in the air and make haze denser. As general scientific context beyond the article, droplets and particles scatter light, so less clear detail reaches the eye.

The article gives a concrete example from November 16: visibility dropped from 6,000 metres toward mist and then fog while humidity and PM2.5 and PM10 concentrations were increasing. High humidity supports fog, but the rise in particulate matter shows that pollution was present too. The combination can therefore produce poor visibility without fitting only one label.

This interaction helps explain why meteorologists consider humidity, visibility and air quality together. The article says early-morning humidity exceeded 75% on almost all days that November, and air quality was very poor on most mornings. It also notes that conditions favouring fog can favour smog, so a dense morning haze may involve both moisture and pollutants.

07

What are PM2.5 and PM10, and how do these particles contribute to air pollution?

PM means particulate matter: tiny solid or liquid particles suspended in air. As general scientific context not defined in the article, PM2.5 refers to particles no larger than 2.5 micrometres across, and PM10 to particles no larger than 10 micrometres. These size labels help describe particle pollution, but the article does not provide a particular concentration reading.

The article reports that PM2.5 and PM10 concentrations increased as visibility fell from 6,000 metres toward mist and then fog on November 16. It also says particulate matter mixes with moisture in the air, making haze denser. Thus, the particles were part of the pollution present during the low-visibility conditions, even when experts described the early hours as fog.

The broader pattern was not limited to that morning. Mahesh Palawat said that on most mornings in the previous fortnight, air quality had been very poor and particulate matter mixed with moisture, making conditions more smog-like. The article’s point is that humidity alone cannot explain visibility: particle pollution and moisture can act together.

This brief was written by AI from the original reporting and checked by other models. Names, figures and quotes come from the source; read it for full context.

Read more in the JupiteX app

Pulse is free. New stories every 4 hours, each one broken into the questions that explain it.

Or read more news on the web