JupiteX Get the app
Science & Technology17 Nov 2026 · about 6 min

ATC routers' ability to broadcast data turned off, being investigated: Duffy

The brief

Officials disabled the routers’ ability to broadcast data. Duffy said this stopped the problematic router’s data from spreading through the network and helped restore service. The change was made as investigators examined the communication failure that led to Friday’s nationwide ground stop. The specific router in Arkansas had been broadcasting data from a radio facility into the wider network. When it was turned on during work to replace copper wire with fiber, officials also saw a system in Amarillo, Texas, begin flooding the system. That Texas system had been replaced about three weeks earlier. After the routers’ broadcasting ability was shut down, Duffy said the issue was resolved. Officials isolated the problem, brought the network back online, and reopened the airspace after the ground stop. The root cause remains undetermined. The Arkansas router and the Texas router are being examined at an L3Harris lab in Florida.

01

What did officials turn off on the air traffic control routers, and how did that help restore the network?

Officials disabled the routers’ ability to broadcast data. Duffy said this stopped the problematic router’s data from spreading through the network and helped restore service. The change was made as investigators examined the communication failure that led to Friday’s nationwide ground stop.

The specific router in Arkansas had been broadcasting data from a radio facility into the wider network. When it was turned on during work to replace copper wire with fiber, officials also saw a system in Amarillo, Texas, begin flooding the system. That Texas system had been replaced about three weeks earlier.

After the routers’ broadcasting ability was shut down, Duffy said the issue was resolved. Officials isolated the problem, brought the network back online, and reopened the airspace after the ground stop. The root cause remains undetermined. The Arkansas router and the Texas router are being examined at an L3Harris lab in Florida.

02

How many of these routers are in the national airspace, and what does that tell us about how widely the system is used?

Officials identified 69 routers in the national airspace and turned off their ability to broadcast data. The figure shows that routers are part of a network extending across the country, rather than just one local installation. It does not reveal how many aircraft use each router or how traffic is divided.

One router in Arkansas was under scrutiny after work to replace copper wire with fiber. Duffy said it had been broadcasting data from a radio facility into the wider network. When it was turned on, a system in Amarillo, Texas, replaced about three weeks earlier, also began flooding the system.

Officials then shut down the routers’ broadcast ability, and Duffy said the issue was resolved. The specific Arkansas router and the Texas router were being examined at an L3Harris lab in Florida. The investigation is still seeking the root cause, so the number alone does not identify which devices were involved or what failed.

03

What happened to flights and travelers when the FAA ordered a nationwide ground stop?

The FAA declared a rare nationwide ground stop at 3:54 p.m. Friday, bringing air travel to a halt. The order followed a communication problem involving air traffic control routers. It meant flights could not depart while officials worked to isolate the issue and assess the network.

Planes already in the air were able to continue flying. But millions of travelers waited for more than four hours to learn when, or whether, their scheduled flights would take off. The FAA lifted the ground stop at 8:15 p.m. Friday. Duffy said officials had isolated the issue and shut down the routers’ ability to broadcast data.

The network came back online, and officials reopened the airspace after the stop was lifted. The article does not give a total for canceled or delayed flights. Officials are still investigating what caused the network problem, including examining routers from Arkansas and Texas at an L3Harris lab in Florida.

04

How could replacing copper wire with fiber cables in Arkansas have led to data flooding other parts of the network?

Officials were replacing outdated copper wire with fiber cables in El Dorado, Arkansas. When the router in that area was turned on, Duffy said, a system in Amarillo, Texas, also began flooding the system. That Texas system had been replaced about three weeks earlier.

Duffy said the Arkansas router was broadcasting data from a radio facility into the wider network. Officials shut down the routers’ ability to broadcast, after which he said the issue was resolved. This describes the sequence and the observed network effect; it does not show that fiber itself caused the flooding.

Officials are investigating both the Arkansas and Texas equipment at an L3Harris lab in Florida. Duffy said they are trying to find the root cause. He also said they had not determined whether the problem involved user or installer error, or a faulty router. The article reports no final technical explanation for how the data spread or why the systems flooded.

05

What roles do the FAA and contractor L3Harris play in investigating and maintaining this equipment?

The FAA is the federal agency responsible for the air traffic control system involved in the disruption. Its team was on site as officials examined the router. Duffy said the FAA was working with the FBI and other law enforcement as part of the investigation.

L3Harris is a government contractor that provides technology and IT support for the FAA. It was carrying out routine maintenance at a remote location, including work to replace copper wire with fiber. The router involved was taken to an L3Harris lab in Florida for examination. L3Harris said it was supporting the FAA’s investigation.

Officials have not determined the root cause. Duffy said they were considering whether there had been user or installer error, or whether a faulty router had been installed. He also said officials had no indication of a cyberattack, while noting the FBI would share any contrary finding. The investigation is intended to establish what caused the network disruption.

06

What is an air traffic control router, and what kinds of information does it pass through the network?

In general, an air traffic control router is a networking device that directs data between connected parts of a system. The article does not give a technical definition or describe the routers’ design, so this is a general explanation. It reports that routers form part of the national airspace system and can broadcast data into the wider network.

In this case, Duffy said the Arkansas router was broadcasting data from a radio facility into the network. Officials also reported problems with communication between controllers and pilots, as well as disruption to radar feeds. Those are among the kinds of information and services the system needs to carry or support.

The router’s broadcast ability was shut down after officials isolated the issue, and Duffy said the network recovered. Investigators are examining routers from Arkansas and Texas to identify the failure. The article does not specify the exact data formats, routing process, or how each router connects to communication and radar equipment.

07

How do controllers use communication and radar data together to keep aircraft safely separated?

In general, controllers use communication with pilots to exchange instructions and information, and use radar data to monitor aircraft positions. Together, these sources help controllers manage aircraft and maintain safe spacing. This is general aviation knowledge; the article does not explain the specific procedures controllers use to separate aircraft.

The incident affected both kinds of information. Duffy said the router problem caused issues with communication with airplanes and disruption to radar feeds. He also described the Arkansas router as broadcasting data from a radio facility into the wider network. Officials shut down the routers’ broadcasting ability to isolate the issue.

The nationwide ground stop halted departures while officials addressed the network problem. Planes already in the air were able to continue flying, and the network came back online after the issue was isolated. Investigators are still seeking the root cause. The article does not say which specific controller tools or separation procedures were affected.

This brief was written by AI from the original reporting and checked by other models. Names, figures and quotes come from the source; read it for full context.

Read more in the JupiteX app

Pulse is free. New stories every 4 hours, each one broken into the questions that explain it.

Or read more news on the web